Marshall JVM410H delivers the flagship JVM series all-valve guitar amplifier head. Marshall JVM410H guitar amplifier heads feature 3 voicings per channel and an all tube design. JVM410H comes loaded with ECC83 preamp and EL34 power amp valves for that classic Marshall tone.
JVM410 features two independent channels consisting of Clean/Crunch and Overdrive channels with each channel having its own set of tone, gain, volume and reverb controls and a master section consisting of dual master volumes, presence and resonance controls. The channels also have three different gain settings; by pressing the channel selection button repeatedly, the amplifier will change from green to orange to red while increasing the gain of the channel. JVM410H amplifiers have almost every modern feature including an effects loop, preamp out/in, silent record mode, fully programmable footswitch, Marshall's DI out they are also MIDI controller-ready.
The 100-Watt Marshall JVM410H uses four EL34 power valves in a "push-pull" configuration. The preamp utilizes five ECC83 preamp valves and offers a pure valve signal path even the reverb drive and recover circuit is valve driven, a single MOSFET has been used in the resonance circuit.
Important Note! “Due to the technical nature of the Marshall Amplification products advertised on this page it is highly recommended that you contact us by telephone or by coming into our store to discuss your particular requirements and to arrange a demonstration before buying any of these products.